This is my ARF version which I have named the "Vortex Vixen" and the "tail art" was produced on my computer and printed with an ALPS MD1000 printer on Kodak sticky-back transparency sheet. The "Delta Vortex" decal on the wing was made by scanning the original supplied one and modifying it to be red rather than the blue-silver. Again, printed same as the "tail art".
Power is a Fox .74 and this plane is a dream to fly. No bad habits that I can detect yet. Haven't flown in any serious wind yet (say, 20+ mph) but sooner or later I will.
I normally fly off asphalt but we also have a 600' grass runway and the Vortex handles fine either way. I use a 13.5 x 6 Boley prop and my ground clearance is a little over 1 inch so the grass runway needs to be kept short.
I didn't fit the original spinner as the cutouts did not come close to matching my Boley prop. Probably some time I will get around to making it fit - in the meantime I will keep the DuBro spinner nut.
Thanks.
